8-13m2 per liter | Full plastic theory coatıng |
Up to 1 hour | Surface drying time |
Up to 3 hour | Time to apply next layer |
matt | Gloss |
No | Flash point |
Standard semi plastic paint grade 2
Nanopush – Standard semi plastic paint, is produced based on Vinyl Acetate Copolymer. This coating color is used for all surfaces of gypsum, cement, concrete, brick, flour and wood indoors . The benefits of this coating color are quick drying, good brushing, excellent adhesion, ease of application and water-thinning ability. The ability to change color with the base of plastic color, lack of unpleasant odor and compatible with environment
Good cover power
Quick drying
Proper pen
Dilute with water
Excellent adhesion
Ease of implementation
Creates seamless, seamless coverage
No odor and chemicals and 100% antibacterial
Adhesion to a variety of surfaces including plaster, cement, concrete, brick, flour and wood.
Resistant to any cracking and resistant to gypsum
Ability to change color with plastic motherboard
Non-toxic, non-flammable and applicable to drinking water
This coating color is used for all surfaces of gypsum, cement, concrete, brick, flour and wood indoors . The benefits of this coating color are quick drying, good brushing, excellent adhesion, ease of application and water-thinning ability. The ability to change color with the base of plastic color, lack of unpleasant odor and compatible with environment
Prepare the surface before painting by removing loose spots, opening gaps, and removing crushed colors . Smooth the surface with plaster or putty, and then use the sand . The final surface before painting should be clean and free of contamination, dirt or grease
1-After the surface has been prepared, dilute all matte nanopoosh color with appropriate amount of water and apply in the surface. The amount of water mixed with the coating color varies according to the ambient temperature, the surface area and the staining device
But in the usual case, the staining rate is 35% – 40% brush, 5% -10% roller and 45% – 50% pistol
2-To achieve a uniformly painted surface, at least two to three stages of painting may be required depending on the surface area
3-It is recommended to apply coating color at ambient temperature above 10°C, surface temperature 3°C above dew point and humidity below 80%
When it finished, wash your hands, paint tools and spilled materials on the ground with warm water and soap if it’s necessary. To prevent rust, rinse paint tools with solvent or water and dry immediately