Nano sealant glue – multi purpose
Note :
The best option for the final insulation of even surfaces that have previously been used with bitumen or insulating materials is white nano white isolation (200 NPS).
It can be stored at 5 to 35 degrees Celsius.
(Avoid direct sunlight and avoid frost)
0.5 liter gallons and 1 liter gallons, 12 gallons per carton
Physical and chemical profile table
Physical stateEmulsion fluid
ColorMilky, after drying
Special Weight1/1 g / cm3
The amount of chlorinedoes not have
Ability to dissolvein the water
PH6-6 / 5

Nano sealant glue – multi purpose

The best insulation for use in sealing and insulation types as additive for cement, concrete, plaster, base water and pure on wooden surfaces and artificial and decorative stones.

Standards :
ASTM 1042 - C1059 - D412 - D624
Properties, Effects and Benefits :

Nanotechnology (permeability to structural depth)

Highly adhesive and 100% insulating with high silicon content

Resistant to gypsum and scaling

Ability to bridge on hair cracks

Resistance to Abrasion, high flexibility

Protects surfaces against carbonation and chlorine ion penetration

Adhesion to a variety of surfaces and create seamless coverage

Very good thermal stability and less shrinkage and more elasticity

Resistance to acidic substances and intrusive salts attack

Highly strong against alkaline and soft inorganic acid solutions

Ease of operation and long durability, creating a flexible layer after drying

It can be painted and it is possible to implement cement mortar and tiling on it

Non-toxic, non-flammable and applicable in the vicinity of drinking water

Applicable on wet surfaces

Application :

For sealing without the need to demolish structures that cause moisture in the decoration of the rubble , the proper failure of the rubble or crochet, the cracking, the insertion of bricks over time, the use of unsophisticated products or the use of chemicals or acids For cleaning and …

Suitable for tile, ceramic, mosaic and all types of stone mixes with cement and stone powder, mixed with all kinds of plastic colors (water base). Alternate water, mixed with plaster or whitening mortar, replaceable water, can be used with brush. And spray for the facade of the building, wood (wooden door towels) and a variety of artificial and decorative stones

Using method and dosage :

1. As a slurry, mix each 1 liter of a nano sealant glue with a cement unit and 2 units of sintered powder (to the extent that the solution becomes a slurry), then thoroughly wash the surface of the desired solution and slurry that applied on tile, ceramic or stone surfaces, and grind the entire surface, and immediately clean the surface with water absorbent without interruption. Then prepare a paste solution with the same formula, and grind the cores. Keep in mind that the other surfaces that have been smeared should be cleaned quickly.
2. Mix with gypsum mortar for 1 liter of the mixture, add 3 to 5 liters of water and add to it the plaster.
3. The mixture is mixed with color (water base or plastic) in pure form or 1 to 1 or 1 to 2 with water and add to the color. Each unit of the product is prepared with water with 10 units of plastic color.
4. This product can be applied purely to insulate and clear on wooden surfaces (sanitary toilets) and all kinds of artificial and decorative stones with brush or spray.
The temperature is then below 75 ° C to + 350 ° C and is environmentally friendly. In contrast of detergent and UV rays and CO2 gas are highly resistant. Antibacterial, anti-moss, algae and bacteria and do not allow the growth and accumulation of these substances at the surface. Positive and negative pressure of water is easily tolerated and is known as a universal material in the insulation industry.

All products