Nano protecting surfaces adhesive
Note :
Keeping
It can be stored at 5 to 35 degrees Celsius.
(Avoid direct sunlight and avoid frost)
contents
Packing
It can be stored at 5 to 35 degrees Celsius.
(Avoid direct sunlight and avoid frost)
Physical and chemical profile table
Physical state Emulsion fluid
Color Milk, after drying, colorless
Special Weight 1/1 g / cm3
The amount of chlorine does not have
Ability to dissolve in the water
PH 6-6 / 5
NPS-320

Nano protecting surfaces adhesive

Another type of nano-based penetrating material is that it can be resistant to water, dust and atmospheric influences without affecting the color and appearance of the penetration into the sections of the sections and eliminating the surface absorption of the site.

A new generation of protective glue with thermal insulation and refrigeration with a new technology

Standards :
ASTM و DIN
Properties, Effects and Benefits :

Nano technology

100% Insulation

Very fast reaction

Non-avoidance of breathing of concrete

No change in color or appearance of the structure

Extensive and cost effective coating

Prevent the absorption and penetration of water in the structures

Penetrating deep into the structure and rapid surface waterproofing

A system based on water and free from volatile organic compounds

Comfortable and easy to use using brushes, rollers or spray

(UV) resistant to ultraviolet radiation

Protect the surface against the growth of moss, mushrooms and algae

Preventing surface contamination, stains and dandruff

Non-flammable, non-toxic

Application :

Brick facades (three centimeters, machine, traditional)

Cement sculptures, Tigra facades, plaster walls

Travertine gems

Wooden surfaces, iron

Historical works and similar types

Using method and dosage :

The surface should be cleaned and free of any grease, dust and dust. The surface should be wet before applying. The nano protecting surfaces adhesive (nps-320) can be used with pistols or brushes.

If the surface area is high, run this product in two layers. Note that we only remove brush or spray once only on the surface, otherwise the desired level will be streaked.

It does not need to be wetted for use on wood.

Can be used with brush or spray every 1 liter of product suitable for 3 to 4 square meters of space.

The temperature is then below 75 ° C to + 350 ° C and is environmentally friendly. In contrast, detergent and UV rays and CO2 gas are highly resistant.

All products