NANO INSULATION ADHESIVE
Note :
The best option for the final insulation of even surfaces that have previously been used with bitumen or insulating materials is white nano white isolation (200 NPS).

Keeping
It can be stored at 5 to 35 degrees Celsius.
(Avoid direct sunlight and avoid frost)
contents
Packing
4 liter gallons, 6 gallons per carton and 20 liter gallons
Physical and chemical profile table
Physical state Milky, after drying
Color Milky, after drying
Special Weight 1/1 g / cm3
The amount of chlorine does not have
Ability to dissolve in the water
PH 6-5
NPS-220

NANO INSULATION ADHESIVE

It is a product with very high bonding strength, usability in sealing and impermeable all building surfaces. It is easy to combine in any type of mortar and is also compatible with a variety of water and plastic base colors.

A new generation of high-strength insulation insulators (isogam and bitoman) with new technology

Standards :
ASTM 1042 - C1059 - D412 - D624
Properties, Effects and Benefits :

Nanotechnology (permeability to structural depth)

Highly adhesive and 100% insulating with high silicon content

Resistant to gypsum and scaling

Ability to bridge on hair cracks

Resistance to Abrasion, high flexibility

Protects surfaces against carbonation and chlorine ion penetration

Adhesion to a variety of surfaces and create seamless coverage

Very good thermal stability and less shrinkage and more elasticity

Resistance to acidic substances and intrusive salts attack

Highly strong against alkaline and soft inorganic acid solutions

Ease of operation and long durability, creating a flexible layer after drying

It can be painted and it is possible to implement cement mortar and tiling on it

Non-toxic, non-flammable and applicable in the vicinity of drinking water

Applicable on wet surfaces

Application :

Sealing and impermeable all surfaces under water pressure, Fully flexible for sealing pools, water tanks, flooring tiles, facade, rain tufts, whitening plaster, base and water paints, and all types of materials Sealing and …

Using method and dosage :

Several methods for insulating with nano insulation adhesive (NPS-220) can be made, some of which are as follows:
1- Mix with cement mortar with a thickness of 1 cm and more. 5 liters of product for 100 kg of cement and a thickness of one centimeter or the same smelting 5 liters of product for 25 to 50 kg of cement (be sure to have a high thickness of sand and low thickness Or fines, even use rock and silica powders)
2. Mix with gypsum mortar for 1 liter of product, add 3 to 5 liters of water to the plaster.
3. Mix with paint (base of water or plastic) 1 unit product with 2 to 3 units of mixed water and add to the paint.
Each unit of the product is prepared with water with 10 units of plastic color.
4. In the form of a brush stroke, add 1 liter of product with 1 liter of water and add 1 unit of cement and 2 units of powdered rock or silica, then thoroughly wash the surface of the target and two level nano insulation adhesive Apply the insulator to the surface as 1 to 1 mixture with brush or spray, and apply the slurry product to the two level first-hand drying time on the surface and re-insulate the product one We apply a mixture of water with two level on the surface of the work as pure.
The temperature is then below 75 ° C to + 350 ° C and is environmentally friendly. In contrast, detergent and UV rays and CO2 gas are highly resistant. Antibacterial, anti-moss, algae and bacteria and do not allow the growth and accumulation of these substances at the surface. Positive and negative pressure of water is easily tolerated and is known as a universal material in the insulation industry.

All products